Test Preparation on Civil Strength of Material Part-2
1.
In a loaded beam, the point of contraflexure occurs at a section where
2.
In actual machines
3.
In the given below figure, the rivets with maximum stress, are:
4.
If two forces acting at a joint are not along the straight line, then for the equilibrium of the joint
5.
Shear deflection of a cantilever of length L, cross sectional area A and shear modulus G, under aconcentrated load W at its free end, is
6.
Forces are called concurrent when their lines of action meet in
7.
The ratio of the maximum deflections of a beam simply supported at its ends with an isolatedcentral load and that of with a uniformly distributed load over its entire length, is
8.
At either end of a plane frame, maximum number of possible bending moments, are
9.
Which of the following is not the unit of work, energy and heat?
10.
If a shaft is rotating N revolutions per minute with an applied torque T kg-m, the horse powerbeing transmitted by the shaft, is
-
Check your progress:
 Right Ans |
 Wrong Ans |
 Not Attempted |