Consider the following statements: 1. Standard penetration test is commonly used for cohesionless soils. 2. Standard penetration test results in respect of a cohesionless soil are correlated to its density index and friction angle. 3. Use of H-value not corrected for overburden pressure leads to highly conservative design of footings at shallow depths. Which of these statements are correct?
2.
Consider the following statements: 1. The benefit of surcharge and depth of foundation is only marginal in case of footings on purely cohesive soils. 2. The bearing capacity of a footing in pure clay increases with increase in size of the footing. 3. Size effects in plate load tests are more important in case of cohesionless soils. Which of these statements are correct?
3.
The mean unconfined compressive strength of a purely cohesive soil was found to be 50 kN/m
4.
The field density and field moisture content of a soil can be determined by 1. Core cutter method 2. Sand replacement method 3. Proctor compaction test 4. Modified proctor compaction test
5.
Consider the following statements: 1. Friction piles are also called floating piles 2. Minimum number of piles to qualify as a pile group is three. 3. The group efficiency of a pile group may be either less than 100% or more than 100%. Which of these statements are correct?
6.
Consider the following statements relating to foundations on expansive soils: 1. Strength should be improved and compressibility should be reduced. 2. Compressibility should be increased. 3. No stabilization should be done. Which of these statements is/are correct?
7.
Consider the following statements: 1. Buried service lines should be avoided in an expansive soil region. 2. A swelling pressure less than 20 kN/m
8.
If L is the length of the chain, W is the weight of the chain and T is the tension, the sag correction for the chain line is
9.
In an inclined terrain, if the elevation difference between the two ends of a line is h and the inclined length of the line is L, the correlation for slope is